Setting up PCI Wireless (Kudzu didn't find the hardware)

Tue Aug 2 12:38:03 UTC 2005

Hello,
After installing FC 4 (minimal installation), I tried adding a PCI Wireless 
card. I had hoped that Kudzu would fine it during booting, but it didn't. 
Here is the output of lspci. How should I set the wireless card? Is it 
supported in FC 4 ? Thank you for any help.

$> lspci -vvv
...
 00:0d.0 Network controller: Intersil Corporation Prism 2.5 Wavelan chipset 
(rev 01)
        Subsystem: Linksys WMP11 Wireless 802.11b PCI Adapter
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- 
Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 64, Cache Line Size 08
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at f4001000 (32-bit, prefetchable) [size=4K]
        Capabilities: [dc] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

00:0e.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 
24)
        Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- 
Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 80 (2500ns min, 2500ns max), Cache Line Size 08
        Interrupt: pin A routed to IRQ 11
        Region 0: I/O ports at 1000 [size=128]
        Region 1: Memory at f4000000 (32-bit, non-prefetchable) [size=128]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0-,D1+,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Reuben D. B.