Configure FC2 as Bridge

[Paul Howarth]

Franco wrote:
> Hi, i have your same output of ifconfig, when i restart
> the network i see that just eth0 is in promiscuous mode seams that
> eth1 don't is in this state. How can i do to change state?

You could use "ifconfig eth1 promisc" to set eth1 into promiscuous mode. 
I don't know what, if anything, you can put into the ifcfg-eth1 file to 
have this happen at boot time though.

> How can i do to controll the bridge ( firewall ) from other network?
> I need to add another NIC CARD ?

You should be able to reach the bridge via the IP address assigned to 
the bridge itself, if you have assigned an IP address to it (which you 
have).

Paul.