Fedora 3 scsi burning problems + controller Tecram + Plextor cdrw

[danjde at tin.it]

Hi at all!
someone of you know if is possible to burn from scsi cdrecorder on fedora
3?
because xcdroast and k3b see only /dev/sg0 and /dev/sg1, but from this kind
of devices is imposible to burn..normally the corrects devices should be
sr or scd
any idea?
many many thanks!!

this is my configuration:

fedora 3, kernel vanilla 2.6.9 with scsi support, udev, and this dmesg output:

dc395x: Used settings: AdapterID=07, Speed=0(20.0MHz), dev_mode=0x57
> dc395x:                AdaptMode=0x0f, Tags=4(16), DelayReset=1s
> dc395x: Connectors: int50  Termination: Auto Low High
> dc395x: Performing initial SCSI bus reset
> scsi0 : Tekram DC395(U/UW/F), DC315(U) - ASIC TRM-S1040 v2.05, 2004/03/08
> dc395x: Target 03:  Sync: 48ns Offset 15 (20.8 MB/s)
>   Vendor: YAMAHA    Model: CRW8424S          Rev: 1.0g
>   Type:   CD-ROM                             ANSI SCSI revision: 02
> dc395x: Target 05:  Sync: 48ns Offset 15 (20.8 MB/s)
>   Vendor: PLEXTOR   Model: CD-ROM PX-40TS    Rev: 1.10
>   Type:   CD-ROM                             ANSI SCSI revision: 02
> sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray
> Uniform CD-ROM driver Revision: 3.20
> Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0
> sr1: scsi-1 drive
> Attached scsi CD-ROM sr1 at scsi0, channel 0, id 5, lun 0
> Attached scsi generic sg0 at scsi0, channel 0, id 3, lun 0,  type 5
> Attached scsi generic sg1 at scsi0, channel 0, id 5, lun 0,  type 5