route syntax
THUFIR HAWAT
hawat.thufir at gmail.com
Mon Jul 11 11:57:00 UTC 2005
On 7/10/05, Michael Schwendt <mschwendt.tmp0501.nospam at arcor.de> wrote:
> On Mon, 11 Jul 2005 04:09:40 +0200, Alexander Dalloz wrote:
...
> According to the current routing table, both eth0 and eth1 point to
> network 192.168.0.0, which is a problem for traffic that is supposed
> to reach eth1.
...
well, I don't know why it works, but it does :)
I pinged caladan from the arrakis D-Link NIC with the following
setup:
from arrakis:
[root at arrakis init.d]#
[root at arrakis init.d]# date
Mon Jul 11 12:27:44 IST 2005
[root at arrakis init.d]# whoami
root
[root at arrakis init.d]# pwd
/etc/init.d
[root at arrakis init.d]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0 0 0 eth1
192.169.1.0 * 255.255.255.0 U 0 0 0 eth0
[root at arrakis init.d]# ./network restart
Shutting down interface eth0: [ OK ]
Shutting down interface eth1: [ OK ]
Shutting down loopback interface: [ OK ]
Disabling IPv4 packet forwarding: [ OK ]
Setting network parameters: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
Bringing up interface eth1: [ OK ]
[root at arrakis init.d]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0 0 0 eth1
192.169.1.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth1
[root at arrakis init.d]# ping 192.168.0.3
PING 192.168.0.3 (192.168.0.3) 56(84) bytes of data.
64 bytes from 192.168.0.3: icmp_seq=0 ttl=128 time=1.59 ms
64 bytes from 192.168.0.3: icmp_seq=1 ttl=128 time=0.481 ms
64 bytes from 192.168.0.3: icmp_seq=2 ttl=128 time=0.472 ms
64 bytes from 192.168.0.3: icmp_seq=3 ttl=128 time=0.487 ms
64 bytes from 192.168.0.3: icmp_seq=4 ttl=128 time=0.467 ms
--- 192.168.0.3 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4010ms
rtt min/avg/max/mdev = 0.467/0.699/1.590/0.445 ms, pipe 2
[root at arrakis init.d]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:0A:E6:A0:24:27
inet addr:192.169.1.2 Bcast:192.169.1.255 Mask:255.255.255.0
inet6 addr: fe80::20a:e6ff:fea0:2427/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:81 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:4718 (4.6 KiB)
Interrupt:5 Base address:0xd400
eth1 Link encap:Ethernet HWaddr 00:0D:88:37:FA:22
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::20d:88ff:fe37:fa22/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:182 errors:13 dropped:0 overruns:0 frame:0
TX packets:98 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:22954 (22.4 KiB) TX bytes:6884 (6.7 KiB)
Interrupt:5 Base address:0xd000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:139 errors:0 dropped:0 overruns:0 frame:0
TX packets:139 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:13021 (12.7 KiB) TX bytes:13021 (12.7 KiB)
[root at arrakis init.d]#
from caladan:
C:\>ping 192.168.0.2
Pinging 192.168.0.2 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
Ping statistics for 192.168.0.2:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
C:\>ping 192.168.0.1
Pinging 192.168.0.1 with 32 bytes of data:
Reply from 192.168.0.1: bytes=32 time<10ms TTL=64
Reply from 192.168.0.1: bytes=32 time<10ms TTL=64
Reply from 192.168.0.1: bytes=32 time<10ms TTL=64
Reply from 192.168.0.1: bytes=32 time<10ms TTL=64
Ping statistics for 192.168.0.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
C:\>
C:\>ipconfig /all
Windows 2000 IP Configuration
Host Name . . . . . . . . . . . . : CALADAN
Primary DNS Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Broadcast
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No
Ethernet adapter Local Area Connection:
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : 3Com EtherLink XL 10/100 PCI
For Complete PC Management NIC (3C905C-TX)
Physical Address. . . . . . . . . : 00-50-DA-68-8C-B2
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
IP Address. . . . . . . . . . . . : 192.168.2.120
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.2.1
DHCP Server . . . . . . . . . . . : 192.168.2.1
DNS Servers . . . . . . . . . . . : 192.168.2.1
Lease Obtained. . . . . . . . . . : Monday, July 11, 2005 4:33:23
AM
Lease Expires . . . . . . . . . . : Monday, July 18, 2005 4:33:23
AM
C:\>
I have no idea why that works, but it does :)
anyhow, I'm now satisfied that the D-Link NIC works under
linux. I've already satisfied myself that the built-in
NIC works under linux.
I'm off to setup masquerading, as per
http://www.tldp.org/HOWTO/Masquerading-Simple-HOWTO/intro.html>.
The only wrinkle is that I'm using an asus wl-330g w-fi
network adapter,
<http://usa.asus.com/prog/spec.asp?m=WL-330g&langs=09>,
and while it can be configured from linux it's easier
to configure it from windows 2000, since arrakis is dual
boot.
so, I'll configure the asus adapter for arrakis from
windows 2000. The adapter, I assume, will have to
connect to the D-Link NIC because that's the NIC
it connects to under windows.
Anyhow, thank you for the help with this thread and
many previous :)
-Thufir
More information about the fedora-list
mailing list