HP2220 printer - does not use global settings

[Kam Leo]

On 7/10/05, Steven Stern <subscribed-lists at sterndata.com> wrote:
> Kam Leo wrote:
> > On 7/10/05, Steven Stern <subscribed-lists at sterndata.com> wrote:
> >
> >>Kam Leo wrote:
> >>
> >>>On 7/9/05, Steven Stern <subscribed-lists at sterndata.com> wrote:
> >>>
> >>>
> >>>>Kam Leo wrote:
> >>>>
> >>>>
> >>>>>On 7/9/05, Steven Stern <subscribed-lists at sterndata.com> wrote:
> >>>>>
> >>>>>
> >>>>>
> >>>>>>In FC4, I used system-config-printer to set up my HP 2220 printer.  In
> >>>>>>the printer properties, print quality is set to "draft". However, when
> >>>>>>printing from any application, it prints out at the "normal" print quality.
> >>>>>>
> >>>>>>Should I be using a different driver than the one presented by
> >>>>>>system-config-printer or should I be setting up the printer in some
> >>>>>>other way?
> >>>>>>
> >>>>>
> >>>>>
> >>>>>Put http://localhost:631 in the location bar of your browser and check
> >>>>>the CUPS web printer administration utility to see if you have
> >>>>>conflicting settings.  If the HP 2220 is using a USB port you may need
> >>>>>to disable the cups-config-daemon service from running on all levels.
> >>>>>
> >>>>
> >>>>It shows up in CUPS as I've configured it via s-c-p.  If I disable CUPS,
> >>>>what tools do I use to manager the 3 printers I'm connected to?
> >>>>
> >>>
> >>>
> >>>I did not and do not recommend disabling CUPS.  What I suggested was
> >>>that you disable the cups-config-deamon service which is a utility tha
> >>>loads at run levels 3-5 and scans the dbus for new hardward.  Follow
> >>>this link, http://www.cups.org/articles.php?L301 , and read about
> >>>cups-config-daemon.
> >>>
> >>
> >>Thanks. I tried that and it still prints in a high quality mode, despite
> >>the global settings.
> >>
> >
> >
> > After you disabled cups-config-daemon did you go into
> > system-config-printer select your printer, change the print quality
> > settigs, and click on "Apply"?  If not, try it again because the
> > settings provided by cups-config-daemon will still be in effect until
> > after you do.  By the way,   check system-config-services and make
> > sure that cups-config-daemon is not set to run at levels 3 and 4.
> >
> 
> Did all that and rebooted as well to make sure X reloaded.
> 

Too bad that none of this helps.  Please file a bug report with CUPS
so the developers can fix it.