FC4 Grub install problems
David Niemi
drn_temp2 at rogers.com
Sat Jul 23 00:26:54 UTC 2005
On Sat, 2005-16-07 at 13:48 +0100, Timothy Murphy wrote:
> Tamer Higazi wrote:
>
> > Is SATA also be treaten as IDE ?! I thought it is treaten as SCSI....
> >
> > It is only a suggestion. If it is treaton on the linux box as scsi, then
> > the devices are numbered from /dev/sd0 to ....
>
> >> > I just installed FC4 i386_x64 onto a system with 2 IDE drives (ntfs)
> >> > and
> >> > 2 SATA drives. The system is set to boot from the first SATA drive in
> >> > the BIOS which I installed fedora to. The upgrade FC3 -> FC4 appeared
> >> > to go well except for the installation of grub. System ran great with
> >> > FC3.
> >> >
> >> > When trying to boot all I get is "GRUB" no prompt or anything. Booting
> >> > from the DVD in rescue mode, mounting the installed FC4 and running
> >> > grub, things appear to not work right. At the grub prompt I cannot get
> >> > any of the TAB completions.
> >> >
> >> > With the old installation grub referenced (hd0,0) now it seems that it
> >> > is (hd2,0). It seems that all of the proper files are located in the
> >> > boot partition.
> >> >
> >> > should I:
> >> > - edit the /boot/grub.grub.conf to refer to (hd2,0)
> >> > - issue grub commands:
> >> > GRUB> root (hd2,0)
> >> > GRUB> setup (hd2)
>
> Not sure if this is relevant,
> but I had a similar problem on a machine with two SCSI disks
> and a large IDE disk which I had added for archiving.
> FC-4 seemed to give my IDE disk precedence,
> although the BIOS looked at my SCSI disk first.
>
> My problem was solved just by saying
>
> grub-install --recheck /dev/sda
>
> However, this may not be relevant to your situation.
On Fri, 2005-15-07 at 17:38 -0500, Jeff Vian wrote:
> Check the mapping of drives in /boot/grub/device.map
>
Thanks for the responses last week but I've been unable to follow up till
now.
The device.map is from the FC3 installation which lists hd0,0 whereas the find
/grub/grub.conf finds it on (hd2,0). When I ran the above commands (root &
setup) things worked fine but I still end up with the system halting at GRUB
when I try booting from the HD. I had changed the grub.conf file to refer to
the (hd2,0) instead of (hd0,0)
So it isn't finding the /grub/grub.conf? Now what should I try?
Thanks
Dave
More information about the fedora-list
mailing list