FC4 Installation problem

[Bisi]

I did not run the interactive system-config-display
tool. How do I run that? Which command do I invoke to
run the interactive tool? When  you ran the
interactive tool, did it resolve the 'Permission
denied' problem?

Bisi

--- Jim Cornette <fc-cornette at insight.rr.com> wrote:

> Bisi wrote:
> 
> >After two attempts, I was finally able to get
> anaconda
> >to install FC4 
> >on IBM 
> >xSeries 240 server in text mode. I edited file
> >/usr/share/hwdata/Cards 
> >inserting the blank line as suggested in the trail
> for
> >bug# 157972. I then ran kudzu, supplying the 
> >root 
> >password when prompted. However, kudzu kept coming
> >back with Permission 
> >denied 
> >even though the root password I supplied is
> correct.
> >
> >I have SELinux enabled (active) during
> installation. I
> >do not know if 
> >this has 
> >anything to do with 'Permission denied' I'm
> getting.
> >
> >Has anyone come accross same problems?
> >
> >Bisi
> >
> >
> >  
> >
> 
> I've seen this problem also trying to launch the
> "new" non-interactive 
> kudzu. The root password that I supplied was also
> correct.
>  Have you tried to run the interactive
> system-config-display tool to 
> configure your card?
> 
> Jim
> 
> -- 
> "Never ascribe to malice that which is caused by
> greed and ignorance."
> -- Cal Keegan
> 
> -- 
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe:
> http://www.redhat.com/mailman/listinfo/fedora-list
> 



		
____________________________________________________
Start your day with Yahoo! - make it your home page 
http://www.yahoo.com/r/hs