[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: VOIP with a linksys PAP2



THUFIR HAWAT wrote:
[root localhost ~]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:0A:E6:A0:24:27
          inet addr:192.168.2.175  Bcast:192.168.2.255  Mask:255.255.255.0
          inet6 addr: fe80::20a:e6ff:fea0:2427/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:6864 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6765 errors:0 dropped:1 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:4312260 (4.1 MiB)  TX bytes:1249117 (1.1 MiB)
          Interrupt:5 Base address:0xd400

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:156 errors:0 dropped:0 overruns:0 frame:0
          TX packets:156 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:16680 (16.2 KiB)  TX bytes:16680 (16.2 KiB)

[root localhost ~]# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.2.0     *               255.255.255.0   U     0      0        0 eth0
169.254.0.0     *               255.255.0.0     U     0      0        0 eth0
default         192.168.2.1     0.0.0.0         UG    0      0        0 eth0
[root localhost ~]# which route
/sbin/route


heh, thanks. I just woke up, but unfortunately must deal with
personal stuff and can't take a further look at this for the moment. however, just getting that info was a big help :)

Indeed, I see no mention of eth1 here, but perhaps its not configured?

Does "ifconfig eth1" tell you anything?

And what is the 169.254.0.0 route from? It looks like an address range that Microsoft Windows uses when it can't find a DHCP server....

Since all 3 routes are via eth0, it looks like all IP traffic from your Linux computer are using eth0. This should/will change if you can configure eth1 correctly with your PAP2 on it.

--
Kevin J. Cummings
kjchome rcn com
cummings kjchome homeip net
cummings kjc386 framingham ma us


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]