FC3 with BEFSR11 Linksys router slow connection

[Shawn Iverson]

On Tuesday, March 22, 2005 9:00 AM Les Mikesell wrote:
>
>Note that if you start down this route you must forever 
>manually set *every* piece of equipment plugged into your 
>network to full duplex.  The problem is that setting one end 
>turns off autonegotiation so if the other end is left at auto 
>it must assume half duplex.  Now that most equipment gets it 
>right I'd recommend loading the latest IOS on your cisco 
>equipment and throw away anything that still doesn't do the 
>negotiation correctly when both ends are set to auto.

My experiences have shown this not to be the case.  The clients are
properly setting themselves to 100/Full, even though the switches are
forced to 100/full, yet the clients are left on autonegotiate.

--

Shawn