FC3 with BEFSR11 Linksys router slow connection

[Les Mikesell]

On Tue, 2005-03-22 at 16:43, Shawn Iverson wrote:
> On Tuesday, March 22, 2005 9:00 AM Les Mikesell wrote:
> >
> >Note that if you start down this route you must forever 
> >manually set *every* piece of equipment plugged into your 
> >network to full duplex.  The problem is that setting one end 
> >turns off autonegotiation so if the other end is left at auto 
> >it must assume half duplex.  Now that most equipment gets it 
> >right I'd recommend loading the latest IOS on your cisco 
> >equipment and throw away anything that still doesn't do the 
> >negotiation correctly when both ends are set to auto.
> 
> My experiences have shown this not to be the case.  The clients are
> properly setting themselves to 100/Full, even though the switches are
> forced to 100/full, yet the clients are left on autonegotiate.

The negotiation process may be smarter now, but I know a few years
back setting a router/switch port to full duplex turned off any
negotiation with the connected device and any device that did
not offer to negotiate was assumed to be half duplex by it's partner.
Either that situation has changed or your clients are doing the wrong
thing even though the result is what you want.  Anyway, these days I
try to leave everything on auto unless I know that even with the
latest firmware/drivers it still won't work.

-- 
  Les Mikesell
   les at futuresource.com