Sequence of SATA Devices
James Wilkinson
fedora at westexe.demon.co.uk
Fri Sep 23 12:29:32 UTC 2005
Harald Schwier wrote:
> I'm using Fedora Core 3, Kernel 2.6.12, with two Promise SATA Controllers.
> One 4 port onboard Promise controller and one 2 port Promise PCI Controller.
> The Kernel detects the PCI controller first and names the attached drive sda
> and sdb.
> The drives attached to the onboard controller are named sdc to sdf.
>
> Is it possible to change this behaviour so that the drives attached to the
> onboard controller are recognised first?
Alexander Apprich wrote:
> Just a best guess, but I think this comes from the BIOS Boot device
> priority. Try switching it there...
If it isn't...
I'm assuming that the onboard four-port Promise controller is also
connected to the PCI bus. In which case, it might be possible to get it
detected after the on-board one by changing which PCI slot the two port
card is in.
In any case, I shouldn't worry about it too much. The device names
aren't particularly user-visible.
Have you manually specified any kernel parameters?
Hope this helps,
James.
--
E-mail address: james | "This thing is bigger than the both of us!"
@westexe.demon.co.uk | "Oh Tom! It's ... it's an elephant!"
More information about the fedora-list
mailing list