How to view what hardware has been detected in FC6
Rick Stevens
rstevens at vitalstream.com
Wed Dec 13 20:13:46 UTC 2006
On Wed, 2006-12-13 at 20:07 +0000, John Bowden wrote:
> Hi Folks
> Finally got FC6 installed and updated on primary drive, after some fun and
> games tying to install it on second drive. I'm using the KDE window manager
> and would like to know how to see what hardware FC6 has found and configured.
> I'm not quite a Linux newbie as I have been useing Mandrake / Mandriva, (No
> flaming please ;-)) for a while now, though this is my first time using
> Fedora.
Welcome to the fold, oh fellow target drone!
> I am a bit of a command line newbie in Linux, Mandriva has some very good GUI
> configuration tools which tends to make one very lazy but I don't mind using
> the command line (I have just downloaded a book on how to use the command
> line and will start perusing it as soon as possible)
Under KDE, use "FedoraLogo->System->Hardware". A useful command-line
tool is "sysreport", but it also reports which software packages are
installed as well and takes a while to run.
----------------------------------------------------------------------
- Rick Stevens, Senior Systems Engineer rstevens at vitalstream.com -
- VitalStream, Inc. http://www.vitalstream.com -
- -
- Try to look unimportant. The bad guys may be low on ammo. -
----------------------------------------------------------------------
More information about the fedora-list
mailing list