[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Odd messages during bootup from gdm

On Thu, 2006-05-04 at 23:06 -0500, Gene Heskett wrote:
> Jim Cornette wrote:
> > Tony Nelson wrote:
> >
> >> SELinux must be active but not enforcing for it to relabel.
> >> ____________________________________________________________________
> >> TonyN.:'                       <mailto:tonynelson georgeanelson com>
> >>       '                              <http://www.georgeanelson.com/>
> >>
> >
> > During the development testing phase, selinux was in a state where 
> > selinux could not even be in permissive mode for booting a kernel. I 
> > relabeled the system with SELinux completely disabled and in runlevel 
> > 1 and was able to boot successfully after relabeling the system.
> > you could argue that sonce the system goes into relabelling once mode 
> > is switched from disabled to enabled, either permissive or enforcing, 
> > relabeling was successful only because of round two relabeling.
> >
> > If my understanding is correct. relabeling is file system related and 
> > selinux does not need enabled in order to add content to the file 
> > system. In order to honor the content within the labled file system, 
> > selinux must be active.
> > If SELinux is active during relabeling, it could prevent file content 
> > to be added to the filesystem. SELinux governs by the rules written to 
> > the file system, if I'm on cue.
> >
> > Jim
> >
> I'll try it one more time, with it enabled.  But it seems to me that if 
> restorecon cannot access the config file, and here I'm ASSUMING that the 
> config file in question is /etc/selinux/config, then I doubt seriously 
> that restorecon can even begin to rectify the problems.
> FWIW, here is an ls -lZa of /etc/selinux/config:
> -rw-r--r--  root     root     system_u:object_r:file_t         
> /etc/selinux/config
> Is that anywhere near correct?  Editing has always been done with vim, 
> as root.

If the system has been relabelled properly, there should be nothing
labelled file_t I believe.

Try to get SELinux booting in permissive mode, by having:
in /etc/sysconfig/config

Try to fix the labels on /etc/selinux:
# restorecon -Rv /etc/selinux

Reboot, and you should get:
# getenforce

When that's working, then try:
# touch /.autorelabel
and reboot again.

I would hope that there is nothing labelled file_t after that.


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]