[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Problem with mounting hard disk after FC5 installation



The loop device work around has made my machine functional again, but I
just hate to leave this issue unsolved.

Ok, perhaps we should collate some more information about this
problem. The output of `hdparm -I` might reveal some sort of
correlation between our problems. I present mine below.

Rob

/dev/hdb:

ATA device, with non-removable media
powers-up in standby; SET FEATURES subcmd spins-up.
	Model Number:       IC35L090AVV207-0
	Serial Number:      [removed] ;-)
	Firmware Revision:  V23OA63A
Standards:
	Used: ATA/ATAPI-6 T13 1410D revision 3a
	Supported: 6 5 4 3
Configuration:
	Logical		max	current
	cylinders	16383	65535
	heads		16	1
	sectors/track	63	63
	--
	CHS current addressable sectors:    4128705
	LBA    user addressable sectors:  160836480
	LBA48  user addressable sectors:  160836480
	device size with M = 1024*1024:       78533 MBytes
	device size with M = 1000*1000:       82348 MBytes (82 GB)
Capabilities:
	LBA, IORDY(can be disabled)
	bytes avail on r/w long: 52	Queue depth: 32
	Standby timer values: spec'd by Standard, no device specific minimum
	R/W multiple sector transfer: Max = 16	Current = 16
	Advanced power management level: unknown setting (0x0000)
	Recommended acoustic management value: 128, current value: 254
	DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
	     Cycle time: min=120ns recommended=120ns
	PIO: pio0 pio1 pio2 pio3 pio4
	     Cycle time: no flow control=240ns  IORDY flow control=120ns
Commands/features:
	Enabled	Supported:
	   *	NOP cmd
	   *	READ BUFFER cmd
	   *	WRITE BUFFER cmd
	   *	Host Protected Area feature set
		Release interrupt
	   *	Look-ahead
	   *	Write cache
	   *	Power Management feature set
		Security Mode feature set
	   *	SMART feature set
	   *	FLUSH CACHE EXT command
	   *	Mandatory FLUSH CACHE command
	   *	Device Configuration Overlay feature set
	   *	48-bit Address feature set
		Automatic Acoustic Management feature set
		SET MAX security extension
		Address Offset Reserved Area Boot
		SET FEATURES subcommand required to spinup after power up
		Power-Up In Standby feature set
		Advanced Power Management feature set
	   *	READ/WRITE DMA QUEUED
	   *	General Purpose Logging feature set
	   *	SMART self-test
	   *	SMART error logging
Security:
	Master password revision code = 65534
		supported
	not	enabled
	not	locked
	not	frozen
	not	expired: security count
	not	supported: enhanced erase
	46min for SECURITY ERASE UNIT.
HW reset results:
	CBLID- above Vih
	Device num = 1 determined by the jumper
Checksum: correct


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]