BOOTPROTO=<protocol>, where <protocol> is one of the following:
none — No boot-time protocol should be used.
bootp — The BOOTP protocol should be used.
dhcp — The DHCP protocol should be used.
BROADCAST=<address>, where <address> is the broadcast address.
DEVICE=<name>, where <name> is the name of the physical device (except dynamically-allocated PPP devices where it is the logical name).
IPADDR=<address>, where <address> is the IP address.
NETMASK=<mask>, where <mask> is the netmask value.
NETWORK=<address>, where <address> is the network address.
class="REPLACEABLE"><answer>, where <answer> is one of the following:
yes — This device should be activated at boot-time.
no — This device should not be activated at boot-time.
USERCTL=<answer>, where <answer> is one of the following:
true — Non-root users are allowed to control this device.
false — Non-root users are not allowed to control this device.
I have not covered all of the parameters you mentioned but with the above you should be able to get things done. I am not an expert but always learning ;-)
Hello there,I am wondering what I am doing wrong here on this =
"/etc/sysconfig/network-scripts/ifcfg-scripts/ifcfg-eth1"? Here is my =
GATEWAY=3D192.168.1.1 (which is how i access my router)
IPADDR=3D not sure whether to put anything here my ip should be gotten =
from the router
NAME=3D not sure if I need to put anything here
DOMAIN=3D I am assuming nothing needs to go here?
If someone can shine some light on this it would be great.Scott