Problem Getting Ip from linksys router

Tod Merley todbot88 at gmail.com
Tue Sep 19 21:48:18 UTC 2006


On 9/19/06, Lucas Fraser (archangelj) <no-reply-gw at fcp.surfsite.org> wrote:
> I've just installed FC5 and everything went fine.
> Tried to pull IP from my Linksys wrt54gc but I can't seem to get
> one.
>
> I decided to try a static but that's not working either. I can
> ping myself but cannot ping the other end.
>
> Any idea's????????
>
>
> --
> This is an email sent via the webforum on https://fcp.surfsite.org
> https://fcp.surfsite.org/modules/newbb/viewtopic.php?post_id=112492&topic_id=26388&forum=28#forumpost112492
> If you think, this is spam, please report this to webmaster at fcp.surfsite.org and/or blame fraserlm at telus.net.
>
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
>

Hi Lucas Fraser!

First things first, do you have the green lights?  Usually when you
plug the ethernet cable into the computer or modem a little light or
two will change usually to green to show you that the physical
connection is working.

Next we move on to the ethernet controller, does the internal PCI bus see it.
# you may need to do /sbin/lspci - Fedora often does not include /sbin in $PATH
--------------------------------------
tod at tod-desktop:~$ lspci | grep -i eth
0000:00:0b.0 Ethernet controller: 3Com Corporation 3c905 100BaseTX [Boomerang]
tod at tod-desktop:~$
----------------------------------------
If you drop "|grep -i eth" you can see all on the bus.  if you add a
"-vv" to "lspci" you can see the very verbose output.  Anyway you can
see that the command found my Ethernet controller.

The problem of seeing if the appropriate driver is installed I have
not yet resolved.

You say you have no IP.  I would guess that you are useing?
---------------------------------------
tod at tod-desktop:~$ ifconfig
eth0      Link encap:Ethernet  HWaddr 00:10:4B:21:8D:A1
          inet addr:192.168.0.18  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::210:4bff:fe21:8da1/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:2176 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1978 errors:0 dropped:0 overruns:0 carrier:0
          collisions:1 txqueuelen:1000
          RX bytes:1394066 (1.3 MiB)  TX bytes:514816 (502.7 KiB)
          Interrupt:10 Base address:0x9400

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:15 errors:0 dropped:0 overruns:0 frame:0
          TX packets:15 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:932 (932.0 b)  TX bytes:932 (932.0 b)

tod at tod-desktop:~$
------------------------------------------
Ifconfig shows my ethernet up, with IP and pretty ready to go.  Next,
do we have a route?
-----------------------------------------
tod at tod-desktop:~$ route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     *               255.255.255.0   U     0      0        0 eth0
default         192.168.0.1     0.0.0.0         UG    0      0        0 eth0
tod at tod-desktop:~$
-----------------------------------------
The first line shows the route to the 192.168.0.0 network (where I am
192.168.0.18 as shown in ifconfig).  The second shows a default
gateway which will be (is) where packets addressed to somewhere else
(www.linux.org) will go.  You are not quite yet to the point where you
are troubleshooting Internet connectivity but there be a preview.

Good Hunting!

Tod




More information about the fedora-list mailing list