[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: FC6 Can't see partition?



On Sun, 2007-01-07 at 14:46 -0500, fedora-list-request redhat com wrote:
> What kind of filesystem is on hdc?  Maybe you need a module that
> wasn't initially installed with FC6.  You can run the
> appropriate fsck from the FC5 rescue disk to make sure that a problem
> hasn't crept in on the drive.  Was it part of an LVM group under
> FC5? 

The filesystem is ext3. I ran fsck.ext3 -f /dev/hdc1 from the FC5 rescue
disk and all was fine. The partition was never part of an LVM group.

Just to restate the original info :

In Fedora Core 6 I can not mount the partition on one of my hard disks.
It was fine in FC5, and I can mount it in the FC5 rescue disk. The
device entries /dev/hdc and /dev/hdc1 exist. It seems like it was
noticed during boot because I see a message in /var/log/messages :

Jan  4 18:21:13 gargon kernel: hdc: 390721968 sectors (200049 MB)
w/8192KiB Cache,CHS=24321/255/63, UDMA(100)
Jan  4 18:21:13 gargon kernel: hdc: cache flushes supported
Jan  4 18:21:13 gargon kernel:  hdc: hdc1

When I try to mount it I get :

sudo mount /dev/hdc1 /tmp/hdc1/
mount: /dev/hdc1 is not a valid block device

The hdc1 does not show up in /proc/partitions nor in /dev/disk/by-path/
where hdc shows up as pci-0000:00:0f.1-ide-1:0 -> ../../hdc

The ide controller is :

00:0f.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
(prog-if 8a [Master SecP PriP])
        Subsystem: VIA Technologies, Inc.
VT82C586/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE
        Flags: bus master, medium devsel, latency 32, IRQ 169
        I/O ports at fc00 [size=16]
        Capabilities: [c0] Power Management version 2

Does anybody know what's going on?

Attachment: signature.asc
Description: This is a digitally signed message part


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]