[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: Preparing FC6 on ASUS A8N-VM CSM with nVidia chipset



On 12/01/07, Lonni J Friedman <netllama gmail com> wrote:
On 1/12/07, Marco Fioretti <mfioretti mclink it> wrote:
> Hello,
>
> I have been asked to upgrade with FC6 x86_64 a computer with an
> ASUS A8N-VM CSM motherboard, with GeForce 6150 and nForce
> 430 chips for on board video, Ethernet and SATA controller.
>
> If I understand correctly, I have to pass some special settings
> and/or drivers from nVidia during, or immediately after
> installation, in order to have full support for all the components
> above.

Where did you read this?  FC6 ships with everything needed.  If you
need 3D accleration for graphics, then you'd need to install the
nvidia X driver after installing the OS,  but beyond that, you
shouldn't need to do anything special.


It may be worth disabling rhgb to avoid a disappearing mouse
pointer bug (which aflicts both nv and nvidia drivers) alternatively
adjust xorg.conf to use a software mouse pointer). I don't use
SATA or hardware RAID, so I don't know if there are any problems
with those.  I do use the ethernet controller with a n430 chipset,
but not on x86_64. As far as installing 32 bit FC6 goes it was
straightforward, but I haven't tried 64bit.

The nvidia driver is needed for dual head support, a 64bit
version can be found in the usual repos.

--
imalone


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]