ethtool not showing details for eth0, only eth1.

[Naoki]

This is odd, I'm trying to work out if I'm correctly set at 100/full on
eth0, but the tool isn't playing nice. ethtool-3-1.2.2

Anybody else got this with Intel Corporation 82547GI Gigabit Ethernet
Controller & 2.6.19-1.2895.fc6xen ?

# ethtool eth0
Settings for eth0:
        Link detected: yes

# ethtool eth1
Settings for eth1:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Full 
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full 
                                100baseT/Half 100baseT/Full 
                                1000baseT/Full 
        Advertised auto-negotiation: Yes
        Speed: Unknown! (65535)
        Duplex: Unknown! (255)
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: umbg
        Wake-on: g
        Current message level: 0x00000007 (7)
        Link detected: no