gcc install/upgrade question
bruce
bedouglas at earthlink.net
Mon Nov 5 02:20:14 UTC 2007
hi...
a basic question.
fc6 comes with gc4.1 . i'm looking to test gc4.2, and would like to have a
parallel dev environment so i have both 4.1 and 4.2.
i'm trying to find pointers on what needs to be done, to make sure i don't
screw up the current 4.1 environment.
it appears that all i need to do is to set a prefix dir when i do the
initial configure.
--./configure --prefix=/gcc42
--make
--make install
this appears to place everything under the gcc42 top level dir. however,
what will i need to do to actually be able to hook into the libs/objs
created by the gcc4.2 build. what will i have to insert into my paths, or
rather where should the information be placed.. in the bashrc/profile
files/etc...
pointers/sites on this would be helpful. haven't been able to find a good
site that walks through this...
once i test 4.2, i'll just rebuild, and rewrite gcc4.1. are there any issues
that i'm going to run into when i do that!
thanks
More information about the fedora-list
mailing list