F10 -- How do I start AR5413 interface?

[Robert Moskowitz]

iarly selbir wrote:
> run the command lspci and see if the "atheros" appears on the output
>
>
> Example, my lspci:
>
> 0c:00.0 Ethernet controller: Atheros Communications Inc. AR242x 
> 802.11abg Wireless PCI Express Adapter (rev 01)

It does. 

03:04.0 Ethernet controller: Atheros Communications Inc. AR5413 
802.11abg NIC (rev 01)
        Subsystem: Atheros Communications Inc. EnGenius EMP-8602 (400mw) 
or Compex WLM54AG (SuperAG)
        Flags: bus master, medium devsel, latency 168, IRQ 17
        Memory at c2100000 (32-bit, non-prefetchable) [size=64K]
        Capabilities: [44] Power Management version 2
        Kernel driver in use: ath5k_pci
        Kernel modules: ath5k


Now what?  How do I define the interface so I can bring it up? And so 
NetworkManager will recognize it?


>
> Regards,
>
> ---------------------------------------------
> iarly Selbir ( Ski0s )
>
>
>
> On Wed, Dec 3, 2008 at 8:42 PM, Robert Moskowitz <rgm at htt-consult.com 
> <mailto:rgm at htt-consult.com>> wrote:
>
>     When I do an ifconfig I only see eth0 and lo.
>
>     system-config-network only shows eth0
>
>     I know the Atheros card is there...
>
>
>     -- 
>     fedora-list mailing list
>     fedora-list at redhat.com <mailto:fedora-list at redhat.com>
>     To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
>     Guidelines:
>     http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
>
>