System crashing when swap hits 25%
John Wendel
john.wendel at metnet.navy.mil
Mon Mar 10 23:20:27 UTC 2008
Todd Denniston wrote:
> Simon Slater wrote, On 03/10/2008 06:37 PM:
>> G'day all,
>> This is an inconvenience that I would like to get to the
>> bottom of. I
>> have a PII 233MHz 512 MbRAM running FC6. All is fine until swap reaches
>> about 25% used then the system hangs. It will run for days with the
>> swap at 10-15%. My first thought was to run badblocks to see if that
>> was the problem, since it is an old drive, but couldn't find the swap
>> device with mount.
>>
>
> Been there, done that.
>
> WARNING: before using badblocks in full rw mode on swap space, remember
> two things:
> 1) some how you would have to convince mkswap to retake what ever label
> is being used in /etc/fstab, or you would need to use a new label/device
> name in /etc/fstab.
> 2) don't be using it for swap while checking it. :)
>
> /sbin/swapon -s
> will display which partitions/files are being used in the system for swap.
> /sbin/swapoff -a
> will turn swap off. probably should shut down any programs down that you
> don't need so that you can get under 512MB, then badblocks (with full
> read/write test and re-`mkswap -c` on it, or Use non-destructive
> read-write mode) sounds like a reasonable thing.
>
> If you find a single bad block, you should really be looking for new
> hardware.
> I have done the thing where you partition around the bad blocks, but it
> only buys you a little time.
> If I understand the man-page for mkswap the -c will print the bad block
> locations, it says nothing of setting up swap to avoid them.
>
>> My questions are: what would cause this system to hang when the swap
>> file is used?;
>
> [from experience I know] Bad blocks in swap cause errors that look
> _just_ like failing ram. That is, programs just die, system locks up in
> weird ways.
>
>> where is the swap file?;
>
> Most times it is a swap partition, `/sbin/swapon -s` or `cat
> /proc/swaps` will help here.
>
>> if in the VG, how do I umount it
>> to run badblocks?
>
> /sbin/swapoff
>
>> Here is some output that may be useful.
>>
>> Thanks.
>
> Good luck.
>
You could make a new swap file ( man mkswap has all the details ) and
use it while you are attempting the repair of the old swap space.
Good luck.
John
More information about the fedora-list
mailing list