Corsair 16G USB Flash Drive

[Les]

Hi, everyone,
I cannot get my F8 system to mount my Corsair flash drive.  I looked at
the Forum, searched Corsair's website, and no joy.

lshal finds it, and lsusb works intermittantly, finding the drive when
it works, but not listing it as a drive, although lsusb seems to hang
quite frequently when the drive is plugged in.

DMESG says:
usb 1-8: new high speed USB device using ehci_hcd and address 3
usb 1-8: configuration #1 chosen from 1 choice
usb 1-8: New USB device found, idVendor=1b1c, idProduct=0ad0
usb 1-8: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-8: Product: Flash Voyager
usb 1-8: Manufacturer: Corsair
usb 1-8: SerialNumber: 00080221D2A41C53EE33
Initializing USB Mass Storage driver...
scsi4 : SCSI emulation for USB Mass Storage devices
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
usb-storage: device scan complete
usb 1-8: reset high speed USB device using ehci_hcd and address 3
usb 1-8: device descriptor read/64, error -110
usb 1-8: device descriptor read/64, error -110
usb 1-8: reset high speed USB device using ehci_hcd and address 3
usb 1-8: device descriptor read/64, error -110
usb 1-8: device descriptor read/64, error -110
usb 1-8: reset high speed USB device using ehci_hcd and address 3
usb 1-8: device not accepting address 3, error -110
usb 1-8: reset high speed USB device using ehci_hcd and address 3
usb 1-8: device not accepting address 3, error -110
usb 1-8: USB disconnect, address 3
scsi 4:0:0:0: Device offlined - not ready after error recovery
usb 1-8: new high speed USB device using ehci_hcd and address 4
usb 1-8: device descriptor read/64, error -110
usb 1-8: device descriptor read/64, error -110
usb 1-8: new high speed USB device using ehci_hcd and address 5
usb 1-8: device descriptor read/64, error -110
usb 1-8: device descriptor read/64, error -110
usb 1-8: new high speed USB device using ehci_hcd and address 6
usb 1-8: device not accepting address 6, error -110
usb 1-8: new high speed USB device using ehci_hcd and address 7
usb 1-8: device not accepting address 7, error -110
hub 1-0:1.0: unable to enumerate USB device on port 8
usb 5-2: new full speed USB device using uhci_hcd and address 2
usb 5-2: device descriptor read/64, error -110
usb 5-2: device descriptor read/64, error -110
usb 5-2: new full speed USB device using uhci_hcd and address 3
usb 5-2: device descriptor read/64, error -110

But the drive mounts and reads correctly under windows.

Any ideas?

Regards,
Les H