F10 64-bit - Wired Ethernet Problems with DNS

[solarflow99]

what does your network use, DHCP?  all it takes for DNS to work is the
/etc/resolv.conf file to list the DNS servers.  If you still cant figure it
out, then a post of your ifcfg-eth0 file would help.



On Thu, Feb 5, 2009 at 1:52 PM, Rick Bilonick <rab at nauticom.net> wrote:

> I installed F10 64-bit on a Dell quad computer without any problems.
> (The computer had been running F5.) I did a fresh install on a new hard
> drive. eth0 worked fine under F5. I can get a connection using ssh and
> IP addresses but I cannot get DNS to work, even though I'm using the
> same DNS addresses (which I can ping). When I use the gui and put in the
> netmask (255.255.255.0), the gui constantly overwrites it. To get any
> connection, I have to go into the eth0 config file and set the netmask.
> (The gui always replaces the netmask IP with either the computer's IP or
> gateway IP - don't remember which.) I can't get this working so I can do
> an update.
>
> Any idea on what is going wrong?
>
> Rick B.
>
> --
> fedora-list mailing list
> fedora-list at redhat.com
> To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
> Guidelines:
> http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/fedora-list/attachments/20090205/51150f86/attachment-0001.htm>