forced to do text-based F11 install

[Aaron Konstam]

On Thu, 2009-07-02 at 18:48 -0400, Andre Robatino wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> On 07/02/2009 06:06 PM, Frank Cox wrote:
> > On Thu, 02 Jul 2009 17:21:13 -0400
> > Andre Robatino wrote:
> > 
> >> is there a walkthrough
> >> anywhere on how to make the resulting system usable?
> > 
> > yum grouplist
> > 
> > Pick the groups you want to install, then
> > 
> > yum groupinstall "name of group" "name of another group"
> > 
> > And so on.
> 
> Good, that sounds not too difficult.  Of course, it assumes that
> networking is working.  Does anyone know how this is done after a
> text-based install?  "ifup eth0" didn't work.
> 
If you are using NetworkManager you turn the internet on by choosing the
eth0 option in the nm-applet in the upper right corner of the panel.

If you are running network then use system-config-network and configure
the eth0 interface, That is thew same as choosing the
System->Administration->Network option

Find out which you are running by using the : chkconfig --list |grep
<program name>


Only one should be running. I would expect by default it is NM.
--
=======================================================================
Don't suspect your friends -- turn them in! -- "Brazil"
=======================================================================
Aaron Konstam telephone: (210) 656-0355 e-mail: akonstam at sbcglobal.net