eth0 problems at boot time !!!
Ron McKown
fedora at ventura.nu
Sat May 8 14:14:52 UTC 2004
It looks like your network card is setup to receive an IP address via
DHCP.
Check to see in /etc/sysconfig/network-scripts/ifcfg-eth0 has a
BOOTPROTO=dhcp in it. if it does, change the value to static, e.g.
BOOTPROTO=static
Ron McKown
On Sat, 2004-05-08 at 17:12, George wrote:
> i ve just installed(upgrate from fc1 ) fc2 test3 relleased and i
> have the following problem .
>
> My eth0 was configured as well , but during initialization i
> received the following message
>
> " Determinign IP information for ...eth0 ... failed . No link
> presented , Check cable ?
> thats all
> and of course i can't connect to my lan and to the internet as you
> imagined ...
> the worst is that i cant even configure my card manualy , i took
> the same message ....
> Please help.
>
>
>
> ______________________________________________________________________
> --
> fedora-test-list mailing list
> fedora-test-list at redhat.com
> To unsubscribe:
> http://www.redhat.com/mailman/listinfo/fedora-test-list
More information about the fedora-test-list
mailing list