ndiswrapper 1.5

[Roger Grosswiler]

Am Mittwoch, den 30.11.2005, 16:28 -0500 schrieb Dave Jones:
> On Wed, Nov 30, 2005 at 10:06:29PM +0100, Roger Grosswiler wrote:
>  > hey, hey...
>  > 
>  > after struggling, i got my card up - but still not online. Dmesg now
>  > says:
>  > 
>  > ndiswrapper version 1.5 loaded (preempt=no,smp=no)
>  > ndiswrapper: driver gplus (D-Link,04/09/2004,6.0.0.18) loaded
>  > PCI: Enabling device 0000:02:00.0 (0000 -> 0002)
>  > ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKD] -> GSI 11 (level,
>  > low) -> IRQ 11
>  > PCI: Setting latency timer of device 0000:02:00.0 to 64
>  > ndiswrapper (IoCreateUnprotectedSymbolicLink:947): --UNIMPLEMENTED--
>  > ndiswrapper: using irq 11
>  > wlan0: vendor: 'TNET1130'
>  > wlan0: ndiswrapper ethernet device 00:0f:3d:59:64:56 using driver gplus,
>  > 104C:9066:1186:3B05.5.conf
>  > wlan0: encryption modes supported: WEP; TKIP with WPA
>  > 
>  > 
>  > iiiiiihaaaaaaaaaaaaaaa!!!!!!! it really was acpi messing it up! acpi=0
>  > on boot resolved it.
> 
> acpi=0 does nothing at all. It's not a valid option.
> You can see this by the fact you still have ACPI: lines in your dmesg.
> 
> 		Dave
> 

*sigh* i was to early, thanks dave - in this case, the noapic option
must have done the trick - or i was even a lucky guy :-D

But, even if i have my card now - i don't get the device to set it
up :-(

Roger