Where does the livna repository fit in with FC9?

[Jim Cornette]

Andrew Farris wrote:
> Jim Cornette wrote:
>> I could not get either nv or nouveau to work for a 7400 NVidia, only 
>> the VESA would work.
>> So these drivers are supposed to work? Thanks for the info.
> 
> Yes, both nv and nouveau should be working.  I can use either one 
> successfully with my fx5900xt agp card.
> 

Is there any special configuration file modification needed? I only seem 
to be able to work with vesa. The below contains information related to 
nvidia and nvidiafb but my results were the same before I installed the 
third party rpms. Interesting to know that they work though.

Jim

00:12.0 VGA compatible controller: nVidia Corporation GeForce 7000M (rev 
a2) (rev a2) (prog-if 00 [VGA controller])
	Subsystem: Hewlett-Packard Company Unknown device 30ea
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- 
<MAbort- >SERR- <PERR- INTx-
	Latency: 0
	Interrupt: pin A routed to IRQ 16
	Region 0: Memory at f5000000 (32-bit, non-prefetchable) [size=16M]
	Region 1: Memory at d0000000 (64-bit, prefetchable) [size=256M]
	Region 3: Memory at f4000000 (64-bit, non-prefetchable) [size=16M]
	Capabilities: <access denied>
	Kernel driver in use: nvidia
	Kernel modules: nvidiafb, nvidia