F9 PreView Anaconda,XEN, Xorg Problems
David M Burgess
davidburgess at sympatico.ca
Mon Apr 21 00:35:24 UTC 2008
I booted from the DVD and followed the prompts. I "installed" not
"upgraded" because that's asking for trouble.
Nothing mysterious or the least be out of the ordinary about that.
On Sun, 2008-04-20 at 10:18 -1000, David Cantrell wrote:
> On Apr 20, 2008, at 4:32 AM, David M Burgess wrote:
> > I've just finished installing the Preview Release on three different
> > hardware platforms.
> >
> > Big problems with them all.
> >
> > I'm installing on dual core 64 bit hardware"
> >
> > Lenovo T61p - dual core Intel
> > Asus A7N-M2 - AMD M2
> > Sun Ultra20 M2 - AMD Opteron
> >
> > All the boxes have 2Gig of RAM and SATA drives, each box also has a
> > NVidia video card - different one in all three.
> >
> > When Anaconda gets to part where you configure the network cards eth0
> > has no check mark but eth1 does and Anaconda is set to configure
> > that by
> > default. A minor problem but still wrong.
>
>
> You didn't provide any information on the install method you used.
> The network interface post configuration screen copies the values used
> during network installation. If you have two NICs, configure eth1 for
> network install, and then get to the post config screen, you will see
> that eth1 is checked and has the settings you flagged during the
> network installation. eth0 will be unchecked.
>
> But, if you can provide some details on the install method you used,
> it would be easier to diagnose.
>
> --
> David Cantrell <dcantrell at redhat.com>
> Red Hat / Honolulu, HI
>
More information about the fedora-test-list
mailing list