No grafics nVidia nForce 750a SLI

[A.J. Werkman]

Installing F10 on an Asus M3N motherboard is not possible in graphics 
mode. Anaconda falls back to text mode.

Also after installation in runlevel 5 it does not start in grafic mode.

My video is:
02:00.0 VGA compatible controller: nVidia Corporation Device 084d (rev 
a2) (prog-if 00 [VGA controller])
	Subsystem: ASUSTeK Computer Inc. Device 82e8
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR+ FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- 
<MAbort- >SERR- <PERR- INTx-
	Latency: 0
	Interrupt: pin A routed to IRQ 5
	Region 0: Memory at fb000000 (32-bit, non-prefetchable) [size=16M]
	Region 1: Memory at d8000000 (64-bit, prefetchable) [size=128M]
	Region 3: Memory at e6000000 (64-bit, prefetchable) [size=32M]
	Region 5: I/O ports at bc00 [size=128]
	[virtual] Expansion ROM at e0000000 [disabled] [size=128K]
	Capabilities: [60] Power Management version 2
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 PME-Enable- DSel=0 DScale=0 PME-
	Capabilities: [68] Message Signalled Interrupts: Mask- 64bit+ Count=1/1 
Enable-
		Address: 0000000000000000  Data: 0000
	Kernel modules: nvidiafb
00: de 10 4d 08 07 01 10 00 a2 00 00 03 00 00 00 00
10: 00 00 00 fb 0c 00 00 d8 00 00 00 00 0c 00 00 e6
20: 00 00 00 00 01 bc 00 00 00 00 00 00 43 10 e8 82
30: 00 00 00 00 60 00 00 00 00 00 00 00 05 01 00 00


Please advice: can I get this working by manually changing config files 
or is this VGA adapter not supported?

Koos.