[Fedora-xen] missing xen-debuginfo-3.4.1-1.fc11.x86_64.rpm

[Jon]

I am following Boris guide at:

http://bderzhavets.wordpress.com/2009/08/20/setup-libvirt-0-7-0-6-xen-3-4-1-dom0-on-to-fedora-11-64-bit/

And after I issue the "rpmbuild -ba ./xen.spec" command and then issue
the yum install xen-3.4.1-1.fc11.x86_64.rpm \
xen-debuginfo-3.4.1-1.fc11.x86_64.rpm \
xen-devel-3.4.1-1.fc11.x86_64.rpm \
xen-doc-3.4.1-1.fc11.x86_64.rpm \
xen-hypervisor-3.4.1-1.fc11.x86_64.rpm \
xen-libs-3.4.1-1.fc11.x86_64.rpm \
xen-runtime-3.4.1-1.fc11.x86_64.rpm

command, I always am missing xen-debuginfo-3.4.1-1.fc11.x86_64.rpm.

Is there a certain package that needs to be installed to get this rpm
and can I get by without it?

Thanks for any help....again :)

Jon

AMD64 fc11 4core proc

[root at localhost x86_64]# cat /proc/cpuinfo 
processor	: 0
vendor_id	: AuthenticAMD
cpu family	: 16
model		: 2
model name	: AMD Phenom(tm) 9500 Quad-Core Processor
stepping	: 2
cpu MHz		: 2210.236
cache size	: 512 KB
physical id	: 0
siblings	: 4
core id		: 0
cpu cores	: 4
apicid		: 0
initial apicid	: 0
fpu		: yes
fpu_exception	: yes
cpuid level	: 5
wp		: yes
flags		: fpu vme de pse tsc msr pae mce cx8 apic mtrr pge mca cmov pat
pse36 clflush mmx fxsr sse sse2 ht syscall nx mmxext fxsr_opt pdpe1gb
rdtscp lm 3dnowext 3dnow constant_tsc rep_good nonstop_tsc pni monitor
cx16 lahf_lm cmp_legacy svm extapic cr8_legacy abm sse4a misalignsse
3dnowprefetch osvw ibs
bogomips	: 4420.46
TLB size	: 1024 4K pages
clflush size	: 64
cache_alignment	: 64
address sizes	: 48 bits physical, 48 bits virtual
power management: ts ttp tm stc 100mhzsteps hwpstate