[Freeipa-users] Reverse Zone IPv6 Syntax ?

[Günther J. Niederwimmer]

Hello,

Am Monday 07 December 2015, 22:46:45 schrieb Martin Basti:
> On 07.12.2015 21:26, Günther J. Niederwimmer wrote:
> > Am Monday 07 December 2015, 20:41:29 schrieb Martin Basti:
> >> On 07.12.2015 20:12, Pavel Picka wrote:
> >>> Hello
> >>> 
> >>> for me working if ipv6 address is e.g. 2002::101 so reverse zone will be
> >>> :
> >>> 
> >>> 0.2.0.0.2.ip6.arpa
> >>> 
> >>> you can use more char as you mentioned ( 0.0.0.0.0.2.0.0.2.ip6.arpa will
> >>> still be reverse for ip 2002::101 )
> > 
> > I tested also more chars ?
> > 
> >>> so if your IP start 2001::   have reverse   2.0.0.1.ip6.arpa
> >> 
> >> Nope.
> >> 
> >> reverse zone of 2001::/16 is 1.0.0.2.ip6.arpa
> > 
> > Is there a command line syntax for adding a reverse Zone, in the web
> > Formula it is not possible to insert a reverse IPv6 zone. I have only the
> > Message this is a wrong IP Address.
> 
> It should work in webUI.
> Did you write ipv6 address with prefix? (2001:db8::/32) ?

No

I have in my Zone only this Addresses
2001:15c0:xxxx:xxxx::234

?
Have I to set all the 0. before the /64 Segment 

> >>> hope it helps
;-).
> >>> 
> >>> ----- Original Message -----
> >>> From: "Günther J. Niederwimmer" <gjn at gjn.priv.at>
> >>> To: freeipa-users at redhat.com
> >>> Sent: Monday, December 7, 2015 7:58:32 PM
> >>> Subject: [Freeipa-users] Reverse Zone IPv6 Syntax ?
> >>> 
> >>> Hello,
> >>> 
> >>> I like to create a ip6.arpa with freeIPA but this is not possible ? I
> >>> can't
> >>> found the correct syntax for a IPv6 reverse Zone :-(.
> >>> I Tested
> >>> 
> >>> 16 Char
> >>> x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2
> >>> x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2.ip6.arpa
> >>> 
> >>> The last is working with named (bind)
> >>> 
> >>> Can any tell me, is this working or have I link to read a Docu
> >>> 
> >>> Thanks for a answer
> >>> 
> >>> FreeIPA Version 4.2.0-15

-- 
mit freundlichen Grüßen / best regards,

  Günther J. Niederwimmer