[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

Re: [K12OSN] How to get terminals to boot on 3.0



David D. Nelson said:
> I'm new to Linux and K12LTSP. I have installed K12LTSP
> 2.1.0 and was able to get a terminal to boot ok. In
> the /opt/ltsp/i386/etc/lts.conf file I had to put the
> following:
>
> [00:04:5a:65:bf:2e]
>          XSERVER            = XF86_SVGA
>          X_MODE_0 = "800x600"
>
> I did a fresh install of K12LTSP 3.0.0 and then added
> the above lines but the boot up goes fine until the
> graphic screen attempts to load.

What is the error message you get when the graphic mode doesn't start?

> I don't really know where to look to find out how to
> set up specific settings for a particular workstation.
> If you know where to point me it would be very
> helpful.

What is your workstation hardware like? More specifically, what is the
video chipset?

-Dan Young
-Parkrose School District






[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]