[K12OSN] dhcp question

[Aaron Leininger]

I thought you all might be able to help me out with something...

I am helping to advise a computer club at my school. I am setting up a linux
server to do some things for them and to demonstrate some of the features of
linux. One of the things I am demonstrating is DHCP. I am running 2 network
cards on the server. 1 of them (eth0 at this point) is set to grab an
address off of the school network and I was hoping to install a dhcp server
and run it on the 2nd nic(eth1). The system says both cards are working
properly and are started. eth0 is grabbing an address off of the school
network fine and is working a-ok. I got dhcp server installed and the
service starts and stops fine but it isn't generating addresses. Is there
some way to tell the dhcp server which nic it is supposed to be serving
addresses through? I did some research online and found only basic setup
references.

Thanks in advance,
Aaron