[K12OSN] Slow printing

[Burke Almquist]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Check the settings in CUPS?
It may depend on which drivers CUPS is using.

On Sep 15, 2004, at 11:50 PM, Sudev Barar wrote:

> One of the users pointed out that the newer DeskJet from HP on USB port
> was printing very slowly as compared to the output when the same 
> printer
> was run under Win.
> Investigation till date reveal:
> 1. The printer is running almost at half the speed for similar mode
> (draft / LQ)
> 2. The printing under K12LTSP4.0  is uni-directional as compared to
> bi-directional under Win
> 3. Some discussion at www.linuxprinting.org about hpijs < ver 1.4 have
> this problem. But even after loading 1.5 this did not go away.
> 4. Some discussion at the same site about switching the BIOS PnP to off
> did not work either.
> 5. Some discussion on RH based system having this problem now under
> investigation by doing a stand alone install of some other distro.
>
> Will report the results, in the meanwhile any one else found this
> problem and any suggested solutions? For record Lasers on /dev/lp0 run
> equally fast under both OS.
> -- 
> Sudev Barar
> Learning Linux
>
>
> _______________________________________________
> K12OSN mailing list
> K12OSN at redhat.com
> https://www.redhat.com/mailman/listinfo/k12osn
> For more info see <http://www.k12os.org>
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (Darwin)

iEYEARECAAYFAkFJgucACgkQfqZR3ThMfXTdSwCePwSFkOGstboNGKHgM7tFy9mw
70QAmgLazxgwg1fWHEScR25kXJCO+0Ip
=kVoK
-----END PGP SIGNATURE-----