[K12OSN] Dual boot using separate hard drives
Petre Scheie
petre at maltzen.net
Thu Jun 2 18:04:40 UTC 2005
I don't think you need to 'leave' any space for the boot loader; when a boot loader is
installed it goes at the beginning of the disk independent of the partitioning and of
the OS, IIRC. Most distros, Fedora/RH included, handle the config of the boot loader
for you automatically. Note that you can also use the Windows boot loader to load
Linux. You can find a bunch of documents about doing this on the web; google for, say,
'windows dual-boot'.
Petre
John P. Conlon wrote:
> I have the drives, I do not have the money to buy a set of caddies.
> Besides that woild not help where my wife is concerned because
> eventually I would forget to switch drives. I do need the file swapping
> ability also.
>
> Gavin Chester wrote:
>
>>On Thu, 2005-06-02 at 10:06 -0600, John P. Conlon wrote:
>>
>>
>>>To ensure marital harmony and bliss I am about to put together a dual
>>>boot machine using 2 hard drives. The plan is for one drive to be
>>>Windows XP and the other to be K12LTSP as a stand alone. When I fdisk
>>>the windows drive do I need to leave a small portion of the drive for
>>>Grub to be installed in? If I do need to leave some how big does the
>>>piece need to be?
>>>
>>>Thanks
>>>Pat
>>>
>>>
>>>
>>
>>This may not be the answer you're looking for, but FWIW I find great
>>service in putting each drive in a harddrive caddy. You don't specify
>>your drive type in your post, but these caddies have been available for
>>SCSI and IDE for some time, and are now available for SATA. Everything
>>is simplified to deciding which drive - Windows or Linux - to pop in at
>>the time of bootup to totally change the personality of the PC. This
>>assumes you go through a complete install of each system on each
>>drive.
>>
>>The only drawback of this is that you can't exchange files between
>>systems on each drive. If you need that then you do need to have both
>>drives active as master and slave (assuming IDE or SATA) at once. In
>>that case simply ensure you have Windows installed on your primary drive
>>and then start your Linux install and the installation will take care of
>>creating the appropriate boot partition for grub or lilo without
>>touching your Windows setup. HTH.
>>
>>I hope that's up to date with current procedures - I haven't had to do
>>what you're attempting for a few years ;-)
>>
>>
>>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> K12OSN mailing list
> K12OSN at redhat.com
> https://www.redhat.com/mailman/listinfo/k12osn
> For more info see <http://www.k12os.org>
More information about the K12OSN
mailing list