[K12OSN] terminal printers

[Julius Szelagiewicz]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

>
>>
>> Jim, I changed "S" to "U" (it was "S" for USB printers), to no avail.
>> modprobe printer causes lsmod to find module "printer", nothing shows up
>> in /dev/usb
>> julius
>
>
> Umm, when you did the modprobe, was the printer plugged in and turned
> on?  It should have found your printer and created the device nodes.
>
> Jim.
>
Jim, the printer is now on and "modprobe printer" creates both printer
module and /dev/usb/lp0.
what do I  do to get it done automagically?
here is the full content of my test lts.conf:
[Default]
        SERVER             = 192.168.0.254
        XSERVER            = auto
   X_MODE_0 = 1280x1024
   X_MODE_1 = 1024x768
        X4_MODULE_01 = glx
        X_MOUSE_PROTOCOL   = "PS/2"
        X_USBMOUSE_PROTOCOL = "IMPS/2"
        X_MOUSE_DEVICE     = "/dev/psaux"
        X_USBMOUSE_DEVICE   = "/dev/input/mice"
        X_MOUSE_RESOLUTION = 400
        X_USBMOUSE_RESOLUTION = 400
        X_MOUSE_BUTTONS    = 3
        X_USBMOUSE_BUTTONS   = 3
        USBEMULATE_3_BUTTONS = "off"
        XkbSymbols         = "us(pc101)"
        XkbModel           = "pc101"
        USE_XFS            = Y
        SCREEN_01          = startx
        SCREEN_02          = shell
        PRINTER_0_DEVICE = "/dev/usb/lp0"
        PRINTER_0_TYPE  = "U"

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)

iD8DBQFCuCGh2LhlZOaj6vURAqHgAKCOFKJ35TLdOgs4/6qij4uKWvHc3ACfRfjY
LQQFmOTgAWv3Nd4tOIdTju4=
=Vyi5
-----END PGP SIGNATURE-----