[K12OSN] Kubuntu LTSP 4.2 XDMCP Problems

[Jim Kronebusch]

> I added the sources to apt and then updated...it's been some time  
> ago, so off the top of my head, I can't remember what apt-sources I  
> used, but I got them directly off the KDE website.

Well I followd Brad's advice and upgraded to KDE version 3.5.2 and now it
boots a client.  The ltspcfg utility still picks up XCMCP as not being enable,
but when I manually configure it shows as being enabled and running.  So I
guess it is working now.

However, it is dog slow.  I mean like a 2 legged dog with one eye.  Exact same
hardware with the FC2 K12LTSP version was smokin.  My term150's booted in
about 20 seconds, now boot time is about 2 minutes.  Any ideas on where to
start?  Top shows CPU usage steadily at less than 1%.  I did notice that when
the X config file is being built a message about limiting ram for X to 97MB. 
I never noticed that before (Maybe staring at it for 2 minutes makes the
unoticed noticable).  Anyhow could this be an indication of a problem?

-- 
This message has been scanned for viruses and
dangerous content by the Cotter Technology 
Department, and is believed to be clean.