[K12OSN] Re: New amer.com switch troubles
jbaillie at stmarys-school.org
Wed Jan 4 04:10:38 UTC 2006
Which gig intel nic?
> I emailed recently about this problem and I want to bring it up again.
> I have a 1gig switch from amer.com and a 1gig intel nic in my server,
> but for some reason the connection between the server and the switch
> will not go over 100meg speed...
> I have tried a couple commands to tell it to re-negotiate, and to tell
> it to go at 1000meg/full duplex, but it always ends up back at
> 100meg/full duplex. This is one of the commands I tried:
> ethtool -s eth0 duplex full speed 1000
> I have had several people suggest the cabling, I will give that
> another try, but it's a long drive to go in and I would like to have
> some other options when I do. What commands should I be running to
> verify the connection, and to change it? Is there any config anywhere
> that might tell it to use 100meg only? Or is it guaranteed to be a
> problem outside of the server?
> I've heard certain kernels have trouble with 1gig speed. I don't know
> what version I have, but I downloaded k12ltsp in early August. Someone
> specifically mentioned that kernel version "2.6.11" and earlier has
> troubles with GB ethernet? Has anyone else ever had similar troubles
> or did it just magically work?
> Also, I am pretty sure the cable is cat5e, and cable from the same
> spool is used between the swithes, and that connection reports 1000meg
> speed on the switch, so the cable should be fine, correct? Unless that
> one cable was badly crimped or by sheer bad luck has a flaw. Someone
> suggested I need cat6 cable, is this true?
> Thanks for your input!
> K12OSN mailing list
> K12OSN at redhat.com
> For more info see <http://www.k12os.org>
More information about the K12OSN