[K12OSN] adding soundcard to the lts.conf file

[Ray Garza]

My client PC's are not detecting and loading the sound module during bootup.

It works fine on the server (both server and client PC's are the same except

the server has all the memory). I'm using K12LTSP 5 and LTSP 4.2 update 3.

Here is the /opt/ltsp/i386/etc/audiolist section on Intel :

#Intel Corporation
8086:2125       i810_audio      #82801AB AC97 Audio Controller
8086:2415       i810_audio      #82801AA AC97 Audio Controller
8086:2425       i810_audio      #82801AB AC97 Audio Controller
8086:2445       i810_audio      #82801BA/BAM AC97 Audio Controller
8086:2446       i810_audio      #82801BA/BAM AC97 Modem Controller
8086:2485       i810_audio      #82801CA/CAM AC97 Audio Controller
8086:7195       i810_audio      #82443MX? AC97 Audio Controller

------------------------------------------------

And here is the lspci -vv section on the sound card:

00:1e.2 Multimedia audio controller: Intel Corporation 82801G (ICH7 Family)
AC'97 Audio Controller (rev 01)
        Subsystem: Dell Unknown device 01ad
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin A routed to IRQ 58
        Region 0: I/O ports at ec00 [size=256]
        Region 1: I/O ports at e8c0 [size=64]
        Region 2: Memory at feabfa00 (32-bit, non-prefetchable) [size=512]
        Region 3: Memory at feabf900 (32-bit, non-prefetchable) [size=256]
        Capabilities: [50] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I noticed that the lspci output says 82801G and there is no listing of it in

the audiolist but I was wondering if I can use one of the others, and if so,

how do I write it in the lts.conf file?

Thanks,

Ray