[K12OSN] nfs troubles

[Craig White]

On Fri, 2007-11-16 at 11:18 -0600, Jon Harder wrote:
> I am having problems booting iMac clients that I believe
> is related to overwhelming them with data.
> 
> This is what I am seeing as they boot up:
> 
> ...
> Mounting root filesystem: /opt/ltsp/ppc from: 192.168.0.254
> Doing the pivot_root
> nfs:server 192.168.0.254 not responding, still trying
> nfs:server 192.168.0.254 OK
> nfs:server 192.168.0.254 not responding, still trying
> nfs:server 192.168.0.254 OK
> nfs:server 192.168.0.254 not responding, still trying
> 
> and these last two lines repeat indefinitely.
> 
> Some searching reveals that this might be related to the old
> computers being overwhelmed with too much UDP nfs traffic from
> the server.
> 
> Originally I tested this setup with a few iMac clients and it
> worked fine. Now that I want to roll it out, I purchased a new
> HP ProCurve 1800-24G switch which is apparently dumping the data
> from the server's Gb connection a lot faster than the switch in
> my original test setup was able to do.
> 
> I hooked six of the iMacs to an old 8 port switch and they all boot
> fine. Once they were up and running, I moved the connections over to
> the new fast switch and they work better, but soon the oldest iMacs
> freeze up.
> 
> One suggestion I found was to force the clients to connect to NFS
> using TCP instead of UDP. I tried playing with 
> 
>   /opt/ltsp/ppc/etc/rc.sysinit
> 
> a little bit to force TCP, but with no apparent success. I use
> tcpdump to monitor the network. The server is pushing out a lot
> of UDP packets!
> 
> Can someone suggest what I might do to ensure the clients are using
> TCP? Or is there a way to throttle the server so that it only sends
> so much traffic to a particular client? Any help would be appreciated.
----
Jon,

I had terrible problems at first and found that the spanning tree
protocol on my Dell switches had to be disabled...I found no other way
around this (reliable way anyway).  The way I discovered/proved the
problem was to make sure that the last switch between client and server
didn't have spanning tree protocol...i.e...

Server -> cheap switch -> expensive switch with spanning tree -> 
                                                       cheap switch ->
                                                              mac client

Or just eliminate the expensive switch entirely from the equation and it
worked fine. 

Then the issue is simply to disable the spanning tree protocol on your
switch if that's the problem

Craig