Device Parameter in Kickstart File
Ronald Reed
rreed at ops.sgp.arm.gov
Tue May 3 20:50:00 UTC 2005
This is what I have found so far:
If you need a device parameter in your kickstart file, and you need more
than 1 module loaded, then separate them with a colon ":". Example:
device scsi aacraid:megaraid:aic7xxx
This should be documented somewhere, because I have searched for days
and found nothing that mentioned this. I had to dig thru the anaconda
source code to figure this out. Hopefully this post will help someone
else too.
Ron
On Fri, 2005-04-29 at 20:58, Dan Carpenter wrote:
> On 4/28/05, Ronald Reed <rreed at ops.sgp.arm.gov> wrote:
> > Anyone know what section of the anaconda code read the device parameter
> > so that I can find it in the source code?
>
> I'm new to this as well. Check out anaconda CVS.
> cd anaconda/loader2/
> look for loadKickstartModule in kickstart.c and modules.c
>
> I don't completely understand you're setup, but maybe you could try
> getting access to the install media and doing all the rest in the %pre and
> %post scripts. I've never had to do this myself...
>
> regards,
> dan
>
> _______________________________________________
> Kickstart-list mailing list
> Kickstart-list at redhat.com
> https://www.redhat.com/mailman/listinfo/kickstart-list
--
===========================
Ron Reed
RedHat Certified Engineer
SGP Computer Department Manager
Unix Systems Administrator
ARM SGP CART Site
(580)388-4053
ron.reed at arm.gov
More information about the Kickstart-list
mailing list