[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]

RE: Kickstart fails



ethtool eth0 

This will give you output that looks like this:

Settings for eth0:
        Supported ports: [ MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Half
        Port: Twisted Pair
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
        Link detected: yes

-----Original Message-----
From: kickstart-list-bounces redhat com
[mailto:kickstart-list-bounces redhat com] On Behalf Of
Elizabeth Brosch thomson com
Sent: Friday, October 07, 2005 2:53 PM
To: kickstart-list redhat com
Subject: RE: Kickstart fails

Chip - what command do I use to see what the NIC is configured at?


_______________________________________________
Kickstart-list mailing list
Kickstart-list redhat com
https://www.redhat.com/mailman/listinfo/kickstart-list


[Date Prev][Date Next]   [Thread Prev][Thread Next]   [Thread Index] [Date Index] [Author Index]