Module loading

[Iain Conochie]

Brian Long wrote:
> Iain Conochie wrote:
> 
>> Morning,
>>
>>     Is it possible to stop the auto probe on a 3.0AS kickstart 
>> installation? I have an adaptec SAS controller card, and the install 
>> program mistakenly uses the aacraid driver to support this device. I 
>> have a drivers disk from IBM (this is an x366 server) which contains 
>> the correct driver but the install program loads the aacraid driver 
>> before i have a chance of using the IBM supplied driver!
>>
>>     Any ideas? Anyone managed to successfully install on this server?
>>
>> Cheers
> 
> 
> You could pass 'nostorage' to newer RHEL 3 kickstarts and it won't probe 
> any storage.  Make sure you also add 'dd' so it prompts for the driver 
> disk.
> 
> /Brian/

Cheers Brian. I found that passing 'noprobe' works as well, however I 
have to manually add the network driver to make sure kickstart worked.

In the end I had to put AS 4.0 on this as none of the drivers seem to 
support the Adaptec SAS card....

Cheers

Iain

> 
> _______________________________________________
> Kickstart-list mailing list
> Kickstart-list at redhat.com
> https://www.redhat.com/mailman/listinfo/kickstart-list


-- 
Iain Conochie UNIX System Administrator UK
COLT Telecom
Units 9-13 Powergate Business Centre, Volt Avenue, London NW10 6PW
Tel: +44 (0) 20 7947 1286
Tel: +44 (0) 78 1514 5493
Email: iain.conochie at colt.net
www.colt.net