[SOLVED] Re: RHEL84 ISO with ks.cfg errors out unable to find installation source

[Joe Wulf]

 I reviewed the Red Hat documentation for performing a standard installation, and in there it explained about needing an 'inst.repo=' assignment on both the 'append' line for BIOS boots, and on the 'linuxefi' line for UEFI boots.  That suddenly made things a whole lot better.
Thanks for those who looked at this for me and with me.... I greatly appreciated your help.
-Joe

    On Wednesday, September 1, 2021, 01:48:28 PM EDT, Joe Wulf <joe_wulf at yahoo.com> wrote:  
 
 The RHEL84 custom boot does see/find/use the ks.cfg, as the %pre section runs successfully, and generates the partition table file in /tmp. This is the exact same code (for %pre, anyway) I've used in recent RHEL7.x ISO builds without problems.  I've followed the Red Hat RHEL 8 docs for Anaconda, as well as for Kickstart, and Performing An Advanced RHEL Installation.

I am just blown away by how hard it is to simply fully boot through to the end of the ks.cfg.  I had none of these issues/problems with RHEL5.x, 6.x and 7.x.
I've carefully looked over both repo lines in ks.cfg and verified the paths are correct.I've provided the relevant lines from isolinux.cfg and grub.cfg (which are simple and straightforward).Boots of either firmware present the same stubborn error state.
I've wondered if my building a RHEL84 ISO on a Centos7 VM could be the issue (how to know for sure?); not that it should matter though.

-Joe
      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://listman.redhat.com/archives/kickstart-list/attachments/20210901/6deabc39/attachment.htm>