[libvirt] [Patch] Libvirt & Autobuild
Daniel P. Berrange
berrange at redhat.com
Thu Jul 10 14:24:53 UTC 2008
On Thu, Jul 10, 2008 at 10:20:26AM -0400, Mohammed Morsi wrote:
> Daniel P. Berrange wrote:
> >On Thu, Jul 10, 2008 at 10:10:25AM -0400, Mohammed Morsi wrote:
> >
> >>Attached is a small fix to get libvirt working w/ autobuild. Autobuild
> >>attempts to create and test the RPM, which lists the PolicyKit as one of
> >>the files to be installed, and thus if it is not installed, autobuild
> >>reports an error and fails. The was to get this file installed is to
> >>specify --with-polkit to ./autogen which I added to the autobuild.sh
> >>build script. (also the syntax check errors broke autobuild, but these
> >>have been fixed according to the latest email on the list). Knock on
> >>wood, after this libvirt should work w/ autobuild and will be built
> >>nightly, and I can finish getting oVirt working with it.
> >>
> >
> >Hmm, this shouldn't impact the RPM spec at all. The 'autogen.shj' call
> >in the autobuild.sh only applies to the non-RPM build. The RPM build
> >is done via 'configure' in the spec file itself. I think there's
> >something else going wrong you're hitting instead.
> >
> I'm not expert on autotools, but doesnt autogen.sh traditionally take
> the configure.ac and Makefile.am files and generate the configure script
> and make rules? While the build process isn't being held up at the
> configure or make stages, rather the rpmbuild stage, rpmbuild depends on
> the output of configure / make, which if --with-polkit is not enabled,
> will result in the PolityKit file not being included in the build and
> thus an error when rpm sees it listed under the files in the spec but
> not the actual file itself. Feel free to correct me if I'm wrong.
autogen.sh creates a generic configure script. The args to configure
only apply to that particular source dir's build - they don't get
propagated through to the RPM spec
This is the sequence:
autogen.sh
configure
make
make dist
rpmbuild libvirt-*tar.gz
-> configure
-> make
-> make install
The args to the first call to 'configure', have no impact on the
2nd configure run which is done by rpmbuild
Daniel
--
|: Red Hat, Engineering, London -o- http://people.redhat.com/berrange/ :|
|: http://libvirt.org -o- http://virt-manager.org -o- http://ovirt.org :|
|: http://autobuild.org -o- http://search.cpan.org/~danberr/ :|
|: GnuPG: 7D3B9505 -o- F3C9 553F A1DA 4AC2 5648 23C1 B3DF F742 7D3B 9505 :|
More information about the libvir-list
mailing list