[libvirt] [PATCH] virsh: improve the help description for managedsave and start

[Justin Clift]

On 10/29/2010 01:35 AM, Eric Blake wrote:
> ACK - both descriptions look okay to me.  But before you push, be sure
> virsh.pod also has similar wording.

Thanks, pushed. :)

Good point about the .pod file too.  Adjusted the descriptions in there
as follows:

 For managedsave

  Save and destroy a running domain, so it can be restarted from the
  same state at a later time.  When the virsh start command is next
  run for the domain, it will automatically be started from this saved
  state.

 For managedsave-remove

  Remove the managedsave state file for a domain, if it exists.
  This ensures the domain will do a full boot the next time it is
  started.

 For start

  Start a (previously defined) inactive domain, either from the last
  managedsave state, or via a fresh boot if no managedsave state is
  present.  The domain will be paused if the --paused option is
  used and supported by the driver; otherwise it will be running.
  If --console is requested, attach to the console after creation.