[libvirt] [PATCH 6/7] qemu: Build command line for the new address format
Paolo Bonzini
pbonzini at redhat.com
Mon Feb 27 17:02:22 UTC 2012
On 02/27/2012 12:59 PM, Osier Yang wrote:
> + _("target must be 0 for leagacy controller "
> + "model 'lsilogic'"));
Remove (misspelled :)) "leagacy".
> + goto error;
> + }
> +
> + virBufferAddLit(&opt, "scsi-disk");
> + virBufferAsprintf(&opt, ",bus=scsi%d.%d,scsi-id=%d",
> + disk->info.addr.drive.controller,
> + disk->info.addr.drive.bus,
> + disk->info.addr.drive.unit);
> + } else {
> + if (!qemuCapsGet(qemuCaps, QEMU_CAPS_SCSI_DISK_CHANNEL)) {
> + if (disk->info.addr.drive.target > 7) {
> + qemuReportError(VIR_ERR_CONFIG_UNSUPPORTED, "%s",
> + _("This QEMU doesn't support target "
> + "greater than 7"));
> + goto error;
> + }
> +
> + if ((disk->info.addr.drive.bus != disk->info.addr.drive.unit) &&
> + (disk->info.addr.drive.bus != 0)) {
> + qemuReportError(VIR_ERR_CONFIG_UNSUPPORTED, "%s",
> + _("This QEMU only supports both bus and "
> + "unit are equal to 0"));
Remove "are".
> + goto error;
Otherwise the series looks good.
Thanks!
Paolo
More information about the libvir-list
mailing list