[libvirt] libvirt unable to start domains

[Zeeshan Ali (Khattak)]

On Fri, Jan 4, 2013 at 1:44 AM, Doug Goldstein <cardoe at gentoo.org> wrote:
> On Thu, Jan 3, 2013 at 3:44 PM, Zeeshan Ali (Khattak)
> <zeeshanak at gnome.org> wrote:
>> Hi,
>>   I updated my libvirt git clone and install yesterday (after about a
>> month or so) and now I can't start domains:
>>
>> $ virsh start fedora18
>> error: Failed to start domain fedora18
>> error: unsupported configuration: This QEMU does not support QXL
>> graphics adapters
>>
>> While libvirt is self-built, I'm using qemu 1.2.2-1.fc18 from vanila
>> Fedora 18 repo. Just to be clear, qemu was not updated before the
>> problem appeared, only libvirt.
>>
>> Here is the libvirtd log:
>> http://static.fi/~zeenix/tmp/libvirtd-session-zeenix.log (13 MB).
>>
>> Also attaching the domain config.
>>
>> --
>> Regards,
>>
>> Zeeshan Ali (Khattak)
>> FSF member#5124
>>
>
> Try the patch I sent in response to your original message. Not sure if
> that's the 100% fix we want. Need to check if we should also be
> checking for SPICE support in qemu_command.c but it should at the very
> least get you going for now.

Thanks, I'll try that.

-- 
Regards,

Zeeshan Ali (Khattak)
FSF member#5124