[libvirt] [python PATCH] build: provide wrapper makefile

[Nehal J Wani]

On Thu, Jun 19, 2014 at 12:51 AM, Eric Blake <eblake at redhat.com> wrote:
> After years of finger training, I'm so used to 'make check' just
> working, that I lose quite a bit of time re-learning that in this
> project, it is spelled 'python setup.py build check'.  A shim
> makefile bridges the gap.
>
> * Makefile: New file.

I see no harm in adding this. Definitely makes a developer's life easier. :)

>
> Signed-off-by: Eric Blake <eblake at redhat.com>
> ---
>
> I'd like to add this to the repo, but even if it gets rejected,
> I'll still keep it in my local tree :)
>
>  Makefile | 18 ++++++++++++++++++
>  1 file changed, 18 insertions(+)
>  create mode 100644 Makefile
>
> diff --git a/Makefile b/Makefile
> new file mode 100644
> index 0000000..6c8da0a
> --- /dev/null
> +++ b/Makefile
> @@ -0,0 +1,18 @@
> +# Shim wrapper around setup.py to allow for familiar build targets
> +
> +PYTHON ?= python
> +
> +all:
> +       $(PYTHON) setup.py build
> +
> +install: all
> +       $(PYTHON) setup.py install
> +
> +clean:
> +       $(PYTHON) setup.py clean
> +
> +check: all
> +       $(PYTHON) setup.py test
> +
> +rpm:
> +       $(PYTHON) setup.py rpm
> --
> 1.9.3
>
> --
> libvir-list mailing list
> libvir-list at redhat.com
> https://www.redhat.com/mailman/listinfo/libvir-list



-- 
Nehal J Wani